Page 2 of 2

Re: SMI levels

PostPosted: Wed Jan 03, 2018 9:30 pm
by Carimwell
To clarify, I do use the heatmap previously developed in response to an earlier request, and I'm grateful for it, but there are two issues with it:
1. the Alert only applies to the OB/OS levels, not the slope of the line which would be useful;
2. While the OB/OS alert works, the colours for slope up/down seem to work for the selection of SMI/Signal line only for the first slot and for the remaining slots the slope seems to apply to the Signal line even if it is the SMI line that is chosen..

Thanks for your help guys!

Re: SMI levels

PostPosted: Fri Jan 05, 2018 6:13 am
by Apprentice
Something like this?
MTF MCP SMI Heat Map with Alert.Carimwell.lua
(16.83 KiB) Downloaded 578 times

Re: SMI levels

PostPosted: Mon Jan 08, 2018 3:24 am
by Carimwell
I have just downloaded this indicator Apprentice and it certainly does look as though it will work. I will test it extensively and report back.

Many many thanks!

Re: SMI levels

PostPosted: Wed Jan 10, 2018 1:27 am
by Carimwell
Thankyou very much for this heatmap Apprentice. Could it possibly be modified to indicate the slope of the Data line, rather than the Signal line. Or if it is easier, provide the user with a choice of which line to use, like the previous heatmap?

Again many thanks for a very useful indicator.

Re: SMI levels

PostPosted: Wed Jan 10, 2018 2:21 pm
by Apprentice
For MTF MCP SMI Heat Map with Alert.Carimwell.lua
You want the slope, SMI / Signal line menu?

Re: SMI levels

PostPosted: Wed Jan 10, 2018 8:52 pm
by Carimwell
Yes please. Or if that is too complex to construct, just make the slope indicator based on the SMI Data line, not the Signal line.
Thanks heaps!

Re: SMI levels

PostPosted: Thu Jan 11, 2018 6:15 am
by Apprentice

Re: SMI levels

PostPosted: Thu Jan 11, 2018 6:34 am
by Carimwell
Fantastic, thanks very much for all your work Apprentice!
Cheers
Carimwell