Page 1 of 1
Tick DMI Strategy
Posted:
Thu Sep 27, 2012 2:54 am
by Apprentice
Long
DI+/DI- CrossOver
Short
DI+/DI- CrossUnder
For signal filtering as a option you can use Tick ADX.
Then, DMI signal is respected, only id ADX is greater than a specified level.
For this strategy, you need to install, TickDmiAdx Indicator.
viewtopic.php?f=17&t=16809&p=31015#p31015
Re: Tick DMI Strategy
Posted:
Fri Jan 05, 2018 8:14 am
by Apprentice
The strategy was revised and updated.
Re: Tick DMI Strategy
Posted:
Wed Nov 28, 2018 4:45 pm
by Gilles
Hi Apprentice,
I just downloaded the strategy and the indicator.
There is a serious problem with the indicator.
If we specify 1 period it sticks visually to the DMI of the trading station. But if we increase the number of periods it becomes imprecise.
Could you remedy that so that our assumptions are feasible.
Regards,
thanks
Re: Tick DMI Strategy
Posted:
Thu Nov 29, 2018 12:39 pm
by Apprentice
Will try to optimize.
As you know, two versions of the indicator use different formulas.
Therefore, the results will never be the same.
Re: Tick DMI Strategy
Posted:
Thu Dec 06, 2018 8:18 am
by Gilles
So the DMI signal is not respected. I do not understand the approach that led to this result so far from the real.
The whole concept is great but if the DMI is not respected, it ruins everything. Impossible to make a correct observation and correct this.
Dear Apprentice, Why create a different formula than the one that determines the DMI. If that is your goal, you should not call it DMI but otherwise.
What do you think dear Apprentice?
Re: Tick DMI Strategy
Posted:
Fri Dec 07, 2018 6:20 am
by Apprentice
To calculate regular DMI you need bar source.
As I use Tick as the source was named Tick DMI.
Two can not have the same result, different data points are used as input.