MTF Schaff Trend Cycle Oscillator Strategy

[Apprentice]

In this example, the trading strategy is only Single (chart) time frame.
Optinal Exits / Filters are not used.

BUY:
1.SCHAFF TREND CYCLE > BUY LEVE ON H1 AND
2.SCHAFF TREND CYCLE > BUY LEVEL ON D1 AND (Optinal)
3.SCHAFF TREND CYCLE CROSS OVER BUY LEVEL ON M15 (Optinal)

SELL:
1.SCHAFF TREND CYCLE < SELL LEVEL ON H1 AND
2. SCHAFF TREND CYCLE <SELL LEVEL ON D1 AND (Optinal)
3. SCHAFF TREND CYCLE CROSSUNDER SELL LEVEL ON M15 (Optinal)

EXIT (Optinal)

EXIT BUY:

1. SCHAFF TREND CYCLE CROSS UNDER EXIT BUY ON M15 OR (Optinal)
2. SCHAFF TREND CYCLE CROSS UNDER EXIT BUY ON IN H1 OR (Optinal)
3. SCHAFF TREND CYCLE CROSS UNDER EXIT BUY ON IN D1 OR (Optinal)

EXIT SELL:

1. SCHAFF TREND CYCLE CROSS OVER EXIT SELL ON M15 OR (Optinal)
2. SCHAFF TREND CYCLE CROSS OVER EXIT SELL ON IN H1 OR (Optinal)
3. SCHAFF TREND CYCLE CROSS OVER EXIT SELL ON IN D1 OR (Optinal)

MTF Schaff Trend Cycle Oscillator Strategy.lua

(20.67 KiB) Downloaded 1055 times

Schaff Trend Cycle Oscillator can be found here.
viewtopic.php?f=17&t=249&start=10

[arstechnica]

do you have some good settings for this strategy?

[Apprentice]

Unfortunately I can not help you here.
I am just a programmer for this one.
In my trading I do not use indicators or strategys.
Try to use Strategy Optimizer tool to find the best settings.

[altonsuny]

Nice post. I like it. Thanks for sharing these information. Keep it up.

[Jabez3]

For some reason I can not run a back test on MTF Schaff Trend Cycle Oscillator Strategy. When setting up the back test there is no "Allow strategy to trade" field. But when I put it on my charts the "Allow strategy to trade" field is there. Any idea why this field is suppressed in back test mode?

[Apprentice]

The strategy was revised and updated.