Hi Paul C,
Thanks for posting the screenshot and your configuration. I'm kind of confused though, you first say it didn't trade, now you are saying it traded too much?
Anyway, I'll try to use my divine thoughts to address everything I think you are trying to say.
"Traded too much"Please see my post above yours where I updated the code to fix a bug related to Multiple Positions. You need to basically specify a value into the CustomID parameter.
"Open more positions than it should according to the chart"Assume this problem isn't caused by the "traded too much" issue above, then the only other thing I can imagine is you are disputing if the signal was generated correctly. So, the question is, was the pivot value crossed when the trade signal was generated?
If you switch on History mode for the Pivot indicator so it draws lines through that date, you'll see that the trades occur exactly at the R1 level, as per your configuration. Here's a screenshot you can match to your screenshot. So, please tell me if you still think there is an issue.
"today did not open any position in AUD / JPY"I ran the configuration you sent me in your latest post through the backtester and it should have traded early in the day as per this screenshot.
So, I'm guessing that since the strategy didn't trade at all, the Allow Trading was off perhaps? Otherwise, I noticed your screenshot is actually in m15 timeframe, not the m5 you sent me in the latest response, which leads me to believe perhaps the strategy was using a different config, so again, this is hard for me to debug. Obviously timing is a factor too, if you turned the strategy on AFTER the price has crossed the appropriate level...
Regardless, I'm not sure what the problem was, but I assume you fixed it since you it was trading in your next post.
Hope this helps.
Cheers,
MooMooFX