by Sensible » Wed May 31, 2023 4:57 pm
Hi Apprentice,
Thanks on the Job done on this EA and the correction for inputing option of Exit at Opposite signal on the input Setting (i.e Close at opposite signal) and taking a trade immediately at the crossover stepma line at the appropriate time.
Here is another correction to make it good for me to trade with.
When I tested the StepMa_EA in the strategy tester, I discovered that the candle was crossing the stepma line severally and I went to EA indicator setup section to adjust the Volty Length and Sensitivity factor to another value to give a few distance to the candlestick to reduced frequent opening of trade but the value does not changed, it like it working with the default value numbers.
So to double check, I drag the normal indicator to the chart to work with it but I find out that the distance between the normal indicator with this value of Length=10 and KV=2.0 and the EA with same value used, the distance is wide between the two: StepMa_EA line and normal indicator line.
Is there any differences between this EA:
Volty Length
Sensitivity Factor
And the normal indicator:
Length
Kv
The usage of word
Help me to check why the volty length and sensitivity factor value is not changing from default value to my choice value to give the Price a little distance to the line.
Or
Am I the one that is not getting the input value numbers right.
Please help me to look into it for correction.
Thanks in advance.